Hi
bit new to this but i have done a funcard and put in machine but it doesnt seem to update. Is there anyway of forcing it to do an update??
box is a sammy 2100c and i am using an infinity reader.
thanks
Hi
bit new to this but i have done a funcard and put in machine but it doesnt seem to update. Is there anyway of forcing it to do an update??
box is a sammy 2100c and i am using an infinity reader.
thanks
on a sammy try this
during a reboot hold down the "<" "ch+" & ">" keys.
when the front panel display reads "Ld14", release the keys and the stb will perform a code download.
this will update the box if the card still doesnt update put in the keys manually
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader.
I am not responsible for what you do with it!
thanks mate will give it a shot!!
sammy sitting at 0 wont move any suggestions
try starting your own thread m8 instead of stealing someone elses and you will get replies as this thread is about updating and not an 0 problem
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader.
I am not responsible for what you do with it!
the box should go through some o f the free channels without the card try unplug put back in while holding the down button in chec to see if there is a red jumper inside the box remove for ten seconds then replace
Bookmarks