-
3/8'' tap washer
ok guys im after the inner hole size of a 3/8'' tap washer
the reason why i want to know is i need a replacement part, drain
valve washer for a lawnmower carb and they dont sell them anymore
only the drain valve kit for which i dont need
-
Re: 3/8'' tap washer
Strip the fooker down and measure the hole thenHidden Content
D I S C LA I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader.
I am not responsible for what you do with it!
-
Re: 3/8'' tap washer
i have stripped it down the the seal washer is perished i cant get a proper
measurement
-
Re: 3/8'' tap washer
I dont know if this helps just found it
Hidden Content
D I S C LA I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader.
I am not responsible for what you do with it!
-
Post Thanks - 1 Thanks, 0 Likes
-
Re: 3/8'' tap washer
cheers but it dont help Hidden Content i need to know the inner hole diameter
between the red lines on first washer
-
Re: 3/8'' tap washer
Hidden Content
????? may be just cant remember if the petrol rots rubber but something like should have the size you need
so long as the centre is a tight fit around the pin thing it should be fine may be i think????
-
Post Thanks - 1 Thanks, 0 Likes
-
Re: 3/8'' tap washer
i did come across them earlier,i think il be able to get away with 3/8'' washer
just the inner hole i need to find out cos theres a plunger that goes thru it
and it and the hole dont want to be bigger then the plunger thickness
-
Re: 3/8'' tap washer
Hidden Content Originally Posted by
Magnu420
Hidden Content
i did come across them earlier,i think il be able to get away with 3/8'' washer
just the inner hole i need to find out cos theres a plunger that goes thru it
and it and the hole dont want to be bigger then the plunger thickness
Well measure the thickness of your plunger then!
Is it a Vernier guage I think you use for that?
-
Re: 3/8'' tap washer
its a tapered plunger diablo,i cant find my vernears or mic atm
ive made a plug guage by using 2mm drill bit,2.5mm drill bit,and a 3mm drill bit
to see if i can judge the size of the hole
feck it il call into a plumbers shop termoz and get a 3/8'' washer they should be cheep enuf
-
Post Thanks - 1 Thanks, 1 Likes
-
Re: 3/8'' tap washer
A leather washer should do it surely, because it should grip the shaft while still being expandable?
-
Post Thanks - 1 Thanks, 0 Likes
Bookmarks