PLEASE FOLLOW THE INSTRUCTION CAREFULLY IF YOU DONT WANT DEAD BOXES WHEN LOADING THE FIRMWARE!


Load grooverider file on to your usb memory stick,make sure power is off on machine and insert the memory stick into the front usb socket
underneath the front flap.


From the main menu go to Utility and then press the right arrow button and select usb
from the right hand side, you will see the grooverider file press ok on it and make sure to select SW+ALL DATA UPDATE..

the machine will update and restart (don't pull your memory stick out until the machine has fully started up)
you now need to scan your channels, NO SPLITTERS ON YOUR INCOMING CABLE WHEN DOING YOUR SCAN
so go to installation press the right arrow button again and go down to AUTO CABLE SEARCH
all you need to change here is the symbol rate.
The symbol rate determines your area for example N*l is 6887, the other numbers are 6952 for Telepe** and EXc&w.
When you have selected your area go to start scan.

once the scan has finished go to menu then highlight accessory and on the remote press the numbers "8989"
you will then see "K*yedit" appear on the right hand side, go to it and press ok and just check that auto update is on if its off just turn it on.

Then go to to your channels by exiting the menu and pressing ok..
Select a non FTA channel and leave it until a picture appears
PLEASE NOTE IT CAN TAKE UPTO 5 MINUTES TO UPDATE SO BE PATIENT

Channel list..


all your channels are categorised by
pressing ok on your remote brings up the channel list but it will be in simple layout,
pressing the red button takes you to detail,
now if your list don't appear to be categorised you will need to press the SAT button on the remote and you need to select cable
at the bottom of the list this will then give you the categories,
to change each section you simply use your left or right arrow buttons





GrooveRider SV6 1.00 : Ethernet Enable sw(STARview6) in Ireland and also fine to works pat** sw in UK

Follow as below procedure

a)Option -> Network -> Net Application -> then select ?Istream? sever ( Ireland sever )

b-1) OSD Setting

Auto Search -> Short CH Name : off ( Ireland ) - on ( UK )

b-a) OSD Setting

Option -> OSD Setup -> Region - > Select 1 in uk ) - select 2 in Ireland

b-c) OSD Setting

If they have 16:9 TV please follow up ? Option -> OSD Setup -> Screen Format


Code:
http://rapidshare.com/files/349694407/GrooveRider_SV6_1.00.ups