Hi all.
I am having problems with a SB5100 after a flash failed. I was using a tcniso blackcat cable and their software and it was going ok but failed to verify about 60%. now I'm getting the no flash detected error. the broadcom chip is identified ok.
I have tried the method using a piece of wire from the +3.3v regulator across the top 5 pins on the 10 pin header and also the running the screwdriver across the legs on the intel flash chip but both do not work for me.
it is not the usb jtag and i'm using SchwarzeKatze v1.34.
I have also tried using JtagUtility v1.3 but get the Address out of range error.
Any ideas guys? been at it most of the day, and it's driving me up the wall now Hidden Content
Klorel
Bookmarks