Hi
Can anyone confirm if the Philips CU1216L/AIGH-3 Cable tuner from a dm7025 is compattable with a dm600pvr?
jbvid
Hi
Can anyone confirm if the Philips CU1216L/AIGH-3 Cable tuner from a dm7025 is compattable with a dm600pvr?
jbvid
Yes...the tuner in the 7025 and 600 are the same. You should be able to swap them without any problems.
Only the very first version of tuner isn't compatible as it's too long for the DM600 but the recent tuners that you can buy will be fine.
Last edited by Devilfish; 13-06-2007 at 04:47 PM.
Hi
Thanks Devilfish, Yes the cable tuner does fit and works fine but the two tuner holes (lnb in/out )in the back panel of the Sat version 600pvr are too far apart for the cable tuners (in/outs) to poke through. Don't really want to file bigger holes yet. Might have a go at some tin work skills to make a second rear panel with suitable holes for cable tuner.
jbvid
There is a different back plate for the cable tuner (easy to fit). Ring Mark at the satstore he should be able to get you one, he might even have some in stock.
D I S C L A I M E R; My right to post information is protected under the rights for freedom act. In all instances information discussed here on my posts are either hypothetical, out of general curiosity, for educational purposes or testing only. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. The user Timoweb is not responsible for what you do with it!
What you could do even though it is a bit of a botch job. Is to cut out a rectangle section and just leave it open so you can use differnt ones whenever you wnat to change
Bookmarks