I have a Sagem Dbox 2xAMD which I need to put into debug mode. I have read PT-1 help files but there seem's to be some conflicting statements on the web between the flash reset and disabling write protect. I was wondering if any one could give me a clear step by step on how to do this.
Is soldering necessary as I am rubbish with electronics and wiring etc.
My chip setup is the one where 2 connections between the two chips are required to connect to a 9V point. PT-1 States this is for flash reset and disabling write protection another site
Hidden Content
states this is for disabling write protection only and to do the flash reset you have to connect pin 12 to GND.
Thanks for reading any help greatly aprecciated.
Colin
Bookmarks