PDA

View Full Version : Di4000 keeps resetting



dmccric
04-06-2006, 05:02 PM
hello, if anyone knows how to stop a Di4000 from resetting I would be very gratefull, after the box get to channel 890, it will reset after a couple of minutes, the time varies now and again but it always resets.

I think a capacitor has been removed as part of a anti-update mod or something. it doesn't reset at all in the engineers menu.

Any thoughts would be great.

thesparky
04-06-2006, 10:18 PM
does the net-id stay correct

dmccric
05-06-2006, 10:32 AM
Hello thesparky,

The net-id does stay the same, 40961, which is what I want. I was thinking that if the voltage rail is fluctuating then the chip might see this condition and just reset, need to get it on a scope on it, some kind of Brown-out detection.

cheers

freddo270
05-06-2006, 04:51 PM
this is the no-update mod for the 4000

http://i6.tinypic.com/11scnr6.jpg

check those two.

if it isnt that then i had a similar prob but with a 1000 - just left it in stream and it sorted itself out.

you could also try force update (if u havent already) or resetting the box (red jumper) and starting over.

the 4000 also has a seperate psu - u could check the output voltages from this where it connects to the main board..

dmccric
05-06-2006, 05:17 PM
well just checked the box & found no capacitor at all for the 1 that should be near pin 20.

I will solder 2 0.1uF capacitors on and then check it.