PDA

View Full Version : AU Fund Card - IRD



pip846
26-05-2006, 07:44 PM
Can any one help to find the IRD number from the card ??????

ByteMaster
26-05-2006, 08:05 PM
Unplug your box then go into eng menu.You have not stated what box you have but if its a P*ce,Hold the up down buttons in the cluster of four ,up,down,left,right.Keep them held in and turn on power keep holding until screen turns blue you can then find your ird normally on page two.It will probably start with 12 ** ** ** it is a 8 digit number (or you can open the box and look on the top of the scart enclosure there will be a sticker on there but this is not a reliable way of checking it as your box may be a clone thus the ird on the sticker will be a fake)
Thats your ird
You then need to reverse the numbers ina special way to add them to the image you are going to make for you fun card.
like this.
If your ird is
12 ab cd 34 you need to put it in on nagra like this
34 cd ab 12

Simple as that..

pip846
26-05-2006, 08:16 PM
My box is pace

ByteMaster
26-05-2006, 08:19 PM
turn upside down and it will say ditv (model number) on sticker.

MingeEater
28-05-2006, 12:45 PM
Can any one help to find the IRD number from the card ??????
Hi,

Do you really mean Ird & BK from the card?

If so make sure auto detect is dissabled on your programmer, then read the flash/inteep and save.
Then read and save your Exteep then use this programme posted
Here (To view links or images in this forum your post count must be 1 or greater. You currently have 0 posts. or Here (To view links or images in this forum your post count must be 1 or greater. You currently have 0 posts. by ice2004

twobeercans
28-05-2006, 01:03 PM
in an au funcard the required information is stored in the ext eep.
when trying to get information from a funcard it should be read in the following way. first disable full auto odetect from you software, if you insert a card while your software is in this mode you will loose information from the card immediately you insert it into the programmer.

first read the int eeprom then save the file as "inteep"
second read the flash and save the file as "flash"
lastly and only when you have done the above.
read the ext eeprom it will tell you the flash will be erased to perform this function hence the reason you save the data first. save this last file as "exteep"
if the card is a rst card or distance nce then you can use boxreader in the downloads also known as fun viewer.
if the card was programmed as an au card then the exteep file is a rom11 image.
you need to drop this exteep file into swapbinhex.exe (usually found in the au funcard software bundle or atmega bundle) this will generate a file called exteep.bin you can open this file in xncs1.8/rom studio or nagraedit.
this will reveal the details you require.