richie19rich77
12-08-2006, 03:08 PM
Hi All,
Ok doing a 4001 for a friend, card was locked to BOD tried unlooper but failed, so was trying the Voltmeter methold before I found out about the pnp SIMM.
Bottom line is that now when I insert simm or the pnp simm I recieve 88:88, if I insert simm from 1000 I get Err2.
I don't think I have a problem with the atmels, but I think I could have fooked the board when removing all soldering points when I was doing the voltmeter methold.
1st question is will a 1000 simm work in a 4001 ?
2nd question is has anyone got a wiring diagram for a 4001?, I could then trace through where I have fooked the board and re-solder a new track.
Maybe I will just tell mate, box is dead, not much I can do lol
Thanks
Ok doing a 4001 for a friend, card was locked to BOD tried unlooper but failed, so was trying the Voltmeter methold before I found out about the pnp SIMM.
Bottom line is that now when I insert simm or the pnp simm I recieve 88:88, if I insert simm from 1000 I get Err2.
I don't think I have a problem with the atmels, but I think I could have fooked the board when removing all soldering points when I was doing the voltmeter methold.
1st question is will a 1000 simm work in a 4001 ?
2nd question is has anyone got a wiring diagram for a 4001?, I could then trace through where I have fooked the board and re-solder a new track.
Maybe I will just tell mate, box is dead, not much I can do lol
Thanks