PDA

View Full Version : cable clips



notanotherone
10-04-2010, 11:31 AM
looking for a fool proof way of putting in cable clips into a rough cast wall,i try and they either bend or they break,you watch the SKY fitters or ariel fitters and they do them no problem

Reddevil
10-04-2010, 11:49 AM
Its possibly they buy better quality ones to what you get in std packs at shops

notanotherone
10-04-2010, 11:51 AM
ive used them all including tower ones i thot these would be better

Cable Tie Mount Black Pack of 100 - Screwfix.com, Where the Trade Buys (http://www.screwfix.com/prods/89036/Electrical-Supplies/Cable-Accessories/Cable-Ties/Cable-Tie-Mount-Black-Pack-of-100)

snowman_sco
10-04-2010, 12:58 PM
there is no fool proof way of doing this ....

the best way i found if its for your own house and you wanna put in the effort

is get 1 1/4" screws raw plugs and a drill remove the nail and use the screw

to time consuming to do it all the time but for your own installation its well worth it

good fixing and they end up nice and straight

dx100-uk
11-04-2010, 03:57 PM
change the nails for mini obo pins ?

dx

Magnu420
12-04-2010, 10:04 PM
i know this might sound silly but

use a smaller lighter hammer like a pin hammer (use for puttin panel pins into wood) into the pointing,if you dont have any pointing if its all pebble dash
it should be ok anywhere,ive never had a prob with puttin cable clips into
walls where i am

if that dont work you can use an hilti gun

http://www.kensalrental.com/Hilti_Gun_pic.jpg :roflmao: