buckthehero
29-06-2009, 02:07 PM
I have two dm600c rigged up in the house, the one in our bedroom works fine - albeit a few duplicate channels that I need to get round to sorting - the one in our front room, which has the same image - will only show the FTA channels - this is now bugging me to the point that I have reflashed it with
PLI Jade image - which it would not even find a transponder
and then back to
Nabilosat Darkstar - which finds the transponder - loads all the channels but will again only show FTA.
What am I doing wrong?
This is bugging the hell out of me
As always a big thanks to any replies left below
Buck
PLI Jade image - which it would not even find a transponder
and then back to
Nabilosat Darkstar - which finds the transponder - loads all the channels but will again only show FTA.
What am I doing wrong?
This is bugging the hell out of me
As always a big thanks to any replies left below
Buck