PDA

View Full Version : No power to motor



Bulld0g
03-05-2008, 01:31 PM
Finally bought a system and started to set it up, but i've hit a problem already.
I'm getting "No or bad signal" on the receiver. When i get up the ladder to look at the motor there is no lights on, on the LED .according to the manual there is a manual button on the motor to drive it East/West and a reset button but nothing happens when i press them.
Now to me it seems the motor is dead. Or am i overlooking someting. Any help would be appreciated.
The motor is a Digipower Diseqc H-H SG-2100. Receiver Technomate 5400.

krazylegz
04-05-2008, 10:23 AM
first thing to check is that you have the motor enabled in the motorised setup screen on the reciever, you should have it set to diseqc1.2. then if thats ok check your coax to make sure its not broke and none of the thin copper braiding is touching the inner copper core