PDA

View Full Version : scanning vertical only



chaz1974
17-03-2008, 05:19 PM
hello folks,

i have lost all my channels. using a tm5500 with a 1.2 motor. everything has been working fine until recently.it is only scanning vertical. anytime i change from v to h the motor does not respond.all cable and connections are ok. it does not save any of the setting. quality is, at times 100% but when i start scanning it says no signal.

any help is appreciated.

thanks
chaz

krazylegz
18-03-2008, 03:22 AM
have you tried doing a factory reset and reflashing new firmware to the reciever m8?

chaz1974
21-03-2008, 09:28 PM
i have done a fatory reset but unable to to do reflsah cos its a tm 5500. about 3 yrs old with positioner. i could not find a f/w for it.

popol
08-04-2008, 10:43 PM
Have you tried the TM support website and see if there is the original firmware after which you could put whatever software is relevant for your box. I guess the software you are using is to get the hac**ed encryptions.

monster1
02-05-2008, 04:35 PM
hi mate my advise to you is first check all your wiring and connections then take it further sometimes the LNB wires do intend to get loose behind the box and if that's OK then flash your box with the original TM firmware patch for your box on the site technomate uk. it should restore all Ur satellites.

monster1
02-05-2008, 04:42 PM
and i forgot to ask you which tm 5500 is it there are few brands of tm5500 there tm5500cip, tm5500cip plus, ci, ci super and ect