pande_monium
05-10-2007, 11:04 PM
if not use dream up. power dower ur box , connect the serial cable and network cable.
power up the box click the connect button. you will see the box connect, wait till its finised loading the boot loader.
then click flash, browse to the image of choice , select it , then watch it load to the box.
disconnect dreamup when it says finished, reboot the box
Renny,
Am flashing with DreamUp.
The box is recognised - ok.
Uploads the flashloader - ok.
Says its in serial HTTP mode...
Then when I try to flash using the Flash button and choose the PLI helenite image, DreamUp gives me a message "Cannot wait for event if event thread is created" and gets stuck at "Calculating Checksum" (both red & green lights are on)!!
Tried rebooting box & doing this all over again... no luck.
Any ideas? Or should I go Mr Dude's route?
power up the box click the connect button. you will see the box connect, wait till its finised loading the boot loader.
then click flash, browse to the image of choice , select it , then watch it load to the box.
disconnect dreamup when it says finished, reboot the box
Renny,
Am flashing with DreamUp.
The box is recognised - ok.
Uploads the flashloader - ok.
Says its in serial HTTP mode...
Then when I try to flash using the Flash button and choose the PLI helenite image, DreamUp gives me a message "Cannot wait for event if event thread is created" and gets stuck at "Calculating Checksum" (both red & green lights are on)!!
Tried rebooting box & doing this all over again... no luck.
Any ideas? Or should I go Mr Dude's route?