PDA

View Full Version : white card



adam
12-12-2006, 11:29 PM
I have got a ?10 white card from jabsplace but it doesnt have an operating system. I am strugling any advice would be helpful.

Datasafe
13-12-2006, 01:52 PM
I find it hard to comprehend why you bought that card, when you could easily have bought a funcard or for a bit extra opos or tit2. A quick search of the forum will tell you these are the cards that have good support here.

I have never heard of that particular card being used, but maybe someone out there has maybe. :Hammer:

cudge
27-12-2006, 01:43 PM
Hiya does it say anything when you put it into your programmer?
I had a white card and it was an atmega 163!
programmed it as an atmega worked fine!
hope this helps!
cudge

adam
27-12-2006, 06:34 PM
The card programmer cannot id the white card because it has no operating system. I gave up on it and got an ATMega card which i have programmed and is working fine but thanks for asking.

opteronics285
27-12-2006, 10:57 PM
Is the programmer software in phoenix mode?

Its easy to put any OS onto the card if it uses the atmel AT90sc6464c chip, just using Winexplorer. ie(TITANIUM 2, KNOT CARD, OPOS, TITAN, PLATINUM). I have the OS's for all these cards so giz a shout and ill send you one. I buy knot cards cos i can get them cheaper then use the opos 1.04 OS on it. Works a treat.

roll
29-12-2006, 01:39 AM
Hi
It could be a tit1 card as there was a lot of those around all white before the tit2 came out. You could try it with a attached operating system updater and loader

Attachment removed no posting files in this section

ross_phill
29-12-2006, 03:04 AM
sorry but whats a whitecard?

mercedese220silver
30-12-2006, 08:48 PM
white card could be fun or titinium etc