View Single Post
  #1 (permalink)  
Old 20-03-2007, 04:22 PM
tabby666's Avatar
tabby666 tabby666 is offline
Junior Member

Thanks: 5
Thanked 4 Times in 4 Posts
 
Join Date: Sep 2006
Age: 36
Gallery: 0
Posts: 17
Points: 2,510.42
Bank: 0.00
Total Points: 2,510.42
Donate
Groans: 0
Groaned at 0 Times in 0 Posts
Rep Power: 0
tabby666 is on a distinguished road
This member is the original thread starter. Exclamation vw remote key feb programming guide

VW remote key fob programming guide
--------------------------------------------------------------------------------
VW/AUDI/SEAT/SKODA
Remote Control Programming (1997 ON)
Procedure
1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the Drivers door using a second
key.
3. Using the remote control press the Unlock button once, and the horn
will sound once.
4. Wait 6 seconds and press the unlock button once to activate the coding
procedure. The remote control will now be programmed.
NOTE : When performing programming on additional remotes the procedure
is the same, except you press the unlock button 2, 3 or 4 times for the
different remote.
For example : If programming 2 remotes press the unlock button twice with
a 1 second interval between each press, repeat for 3 and 4 remotes.
5. Switch Ignition OFF.
6. Remove key from ignition and check for operation.
7. The coding procedure can be repeated up to 4 times for additional remotes.
8. The ignition must be switched OFF between programming each remote
control.
Remote Control Erasing (1997 ON)
Procedure
1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the Drivers door using a second
key.
3. Press the remote control unlock button 5 times in 1 second intervals.
A short horn will sound.
4. Wait 6 seconds and press the unlock button once to activate memory
erase.
5. Switch ignition OFF, all remotes are now erased.
Models Covered:
· Lupo
· Polo
· Golf
· Bora
· Passat
· Sharan (Only Mk2 models as far as I know though)
P.S I HAVE TRIED THIS AND IT DID NOT WORK FOR ME AND THIS GUIDE WAS BOUGHT FROM EBAY BUT YOU NEVER KNOW IT MIGHT WORK FOR 1 OF YOU GUYS!
THIS GUIDE IS NORMALLY USED IF YOU HAVE PURCHASED A KEY FROM EBAY OR ELSEWHERE OR EVEN SO IF YOU REPLACED BATTERY AND THE FOB HAS STOPPED WORKING!
THE PART NO OF THE NEW KEY SHOULD BE THE SAME AS YOUR ORIGINAL KEY, THE NO CAN BE FOUND BY SPLITTING THE KEY IN HALF WITH A BIT OF BRUTE FORCE OR USE SOMETHING LIKE A KNIFE TO SPLIT IT CAREFULLY!
GOOD LUCK GUYS HOPE IT WORKS FOR YOU
Reply With Quote
 
[Output: 16.16 Kb. compressed to 15.36 Kb. by saving 0.79 Kb. (4.90%)]